YEAR: 1970
Material: Hr, Cr Steel
Shear Strength: 60,000 PSI
Width: 64″ (66″ Untrimmed)
Thickness: 0.065″ To 0.500″ (Edge Trim only on 0.625″)
Coil Size:
I.D.: 24″ To 30″ Entry
30″ Exit
O.D.: 90″ Entry and Exit
Coil Weight: 100,000 Lbs. Max.
Line Direction: Left to Right
Line Speed: Low – 30 FPM to 150 FPM
High – 90 FPM to 450 FPM
Cuts:
Low Speed: 5 Cuts 0.500″
7 Cuts 0.375″
8 Cuts 0.312″
10 Cuts 0.250″
High Speed: 10 Cuts 0.065″ – 0.187″
Consisting of the following:
-Coil Entry System:
100,000 Lbs. Capacity
3 Coil Storage & Feed Ramp
Pit Type Coil Car
-Double End Cone-Type Uncoiler:
24″ – 30″ I.D. Range
Power Feedup by AC Motors
Dual Wichita Air Brakes
-Peeler:
Over & Under Peeler Tables with Hydraulic Power
Overarm Feedup Roll
-Edge Guide System: Upgraded in 1997
Hydraulic Power Unit w/20 HP AC Motor
Rexroth 32 GPM variable volume pump
100 Gallon Reservoir
-Flattener:
Entry Side Guides
2 – 12″ Diameter Entry Driven Pinch Rolls
5 Roll Flattener
2 over 3 Rolls
200 HP DC Motor
-Entry Driven Pinch Rolls:
5 HP AC Motor, 1800 RPM
-Slitter Head:
66″ Wide
12″ Dia. Arbors
Parallel Arbor Adjustment, Driven by 5 HP AC Motor
Main Drive: 250 HP DC Motor, 1150/1800 RPM
Quick Set Locking Knives
-Dual Scrap Choppers:
100 HP DC Motor on each Chopper
Power Scrap Conveyor Receives Scrap and Carries it away to a Hopper
-Transfer Table:
Hydraulic Lift & Lower
-Recoiler:
100,000 Lbs. Capacity
66″ Face x 30″ Dia. Drum
Hyd. Drum Expansion by 14″ Bore Cylinder
Hydraulic Pushoff
250 HP DC Motor, 500/1600 RPM
-Free Standing Overarm Separator:
-Exit Coil Car:
Pit Type
-Drive and Control System: New in 2006
Allen Bradley FlexPak 3000 DC Drives with ControlLogix Processor.
There are (3) separate ControlNet networks, each handled by a
separate AB #1756-CNB module.
The chassis also contains local discrete input and output modules,
as well as an ethernet module (AB #1756-ENBT), which connects the
system to a Wonderware InTouch HMI, showing the status of the
drive system and alarms.
-Hydraulics: Complete system upgraded in 2006.
-Includes:
Large amount of Tooling; Knives, Spacers, Rubbers and Overarm Tooling
The Knives are the Quickset Type.
Full set of Manuals, Mech. and Elect. Drawings
Large amount of Spare Parts.
